|Search the Knowledgebase
||Browse by Category
|How do I use trigger INTERACTION in the drumKAT?
Interaction Screen allows you to suppress interaction from one trigger
to another (if you hit one Trigger and another Trigger that is mounted
on the same stand also plays - that is interaction.) Enter the PRE-EDIT
Screens by pressing down on Footswitch1 and releasing. Then, hit PAD8 4
times to see the TRIGGER ADJUST Screen 3: <<<TRG1(TRG1-9 or
DKAT) interaction, matrix:, amt=OFF(OFF, 6-200%) 10(10-130)ms, Ft1
& hit dk hard>>> The settings are determined
automatically for you by the drumKAT if you hit the Trigger hard. The
matrix is which other Triggers play a little when you hit this one. The
amount is how much of a signal is seen on the other Triggers when you
hit this one. The “10ms” is how long the false signal is seen on the
other Triggers after the actual Trigger is hit. See Chapter 10 in the
drumKAT manual, “TRIGGERING”, for more detailed information. (SOUND ADV
will increment the Trigger # for you.)
Thank you for rating this answer.
Hit SCREEN ADV and you'll see TRIGGER ADJUST SCREEN 4:
#of scans, to measure peak, of trigger inputs, trg1 6(3-9)
SCANS>>> Here you select how many Scans or snapshots to look
at the Trigger signal before deciding how big of a signal it is. The
smaller the number of Scans, the quicker the signal will play (less
delay). The bigger the number of Scans, the more accurate the
determination of how hard you hit it. Basically, the goal is to find
the smallest number that gives accurate dynamics. Good Trigger pads are
fine with 3 or 4 Scans. Acoustic Triggers and Trigger pads with a poor
signal require 7 to 9 Scans to properly see the real dynamics of your
playing. See Chapter 10, “TRIGGERING”, for more detailed information.
(SOUND ADV will increment the Trigger # for you.)
No attachments were found.