KAT Percussion Alternate Mode KnowledgeBase

Knowledgebase Home | Glossary | Favorites | Contact Knowledgebase Home | Glossary | Favorites | Contact
Search the Knowledgebase Browse by Category
How do I change pad sensitivity on the dk10?
User Opinions
66% thumbs up 33% thumbs down (3 votes)

How would you rate this answer?
Helpful
Not helpful
How do I increase/decrease the sensitivity of the pads?

Software version 1.4 allows you to Increase / decrease pad thresholds. Increasing the sensitivity makes the DK10 more sensitive to light playing.

To Increase the Sensitivity

  1. Hold down Pads 4 and 5 at the same time, then depress the Note EDIT Footswitch (while still holding down the 2 pads).
  2. You will then hear a single confirmation beep for each time you repeat this procedure. After the 7th level increase (the highest), you will hear an error beep not allowing you to raise it further.

*Note... it is possible for you to make the DK10 too sensitive where the pads will trigger themselves. If this happens, Reduce the pad sensitivities or simply turn the DK10 off. This will reset the pads.

To Decrease the Sensitivity

  1. Hold down Pads 5 and 6 at the same time, then depress the Note EDIT Footswitch (while still holding down the 2 pads).
  2. You will then hear a single confirmation beep for each time you repeat this procedure. After the 7th level Decrease (the lowest), you will hear an error beep not allowing you to lower it further.
Related Questions
No related questions were found.
Attachments
No attachments were found.

Powered by ActiveKB Knowledgebase Software