Service Parts:

The KF1 (Single Footswitch) comes standard with all KAT Controllers, but additional KF1s can be purchased to take advantage of the multi footswitch inputs on the controllers."Normally Open" momentary footswitch.

eKIC

An incredibly sensitive and dynamic "reverse beater" bass drum trigger that uses your own bass drum pedal (or ours...)

Superior Performance The eKIC uses the same "nuBounce" material that is currently used on the malletKAT and trapKAT. This nuBounce material has a very dense molecular makeup, transferring with ease soft hits to the sensor. Because of its density however, it becomes more resistant to harder hits, allowing for harder playability before the sensor reaches dynamic saturation.

See the eKIC on YouTube

eKIC Trigger with Bass Drum Pedal


eKIC Trigger Only

See the eHAT on YouTube

eHAT Trigger with Bass Drum Pedal


eHAT Trigger Only

This trigger device has some interesting unique new features never seen on a hihat pedal.

• fits underneath your existing bass drum pedal (with a bottom plate)
• allows for an adjustable feel using the springs and settings on your favorite pedal
• superior feel because your using a real pedal
• better response because it’s a real bass drum pedal!

• input one is a standard mono ¼ jack input for continuous controller hihat
• input two is a stereo jack input designed for the DITI™.  It includes the CC control output, plus a separate sensor for the chick.  This means real velocity by trigger striking.  All others use generated chick by interpreting the speed and movement of the linear pot
• input three is a velocity controlled trigger output.  Use it for chick or any other sound

• The hihat controller has the widest dynamic range of any pedal on the market.  We designed it that way because the DITI™ will “see” over 800 levels of position on your pedal.  This will ensure the smoothest range from open to closed.  

The TapKAT is a specially modified footswitch that sends a single velocity level when pressed. Industrial strength Velcro keeps the TapKAT in place and it works with most trigger interfaces. Least expensive trigger pedal on the market!

The ePedal Pro AM is the new benchmark for Hi Hat trigger pedals to stand up to. Hart Dynamics specially designed and optimized the ePedal Pro for KAT Percussion.

Features:

• Super Heavy Duty design.
• Fully variable (open > closed) control.
• Velocity sensing "foot chic" and "foot splash".
• Adjustable closure point.
• Extra large cast hardened aluminum footboard.
• Powder coated steel non-slip base with Extreme Velcro bottom.
• As close as it gets to acoustic HH cymbal response.
• Extremely quiet and compatable with all "variable Hi Hat" type modules.
• 1/4" connector output format.

Yamaha HiHat Controller (includes special cable for drumKAT compatibility). This foot pedal makes possible techniques such as fully open, fully closed, half open, foot splashed etc. The height of the footboard is adjustable and the pedal is also equipped with spurs to prevent slippage.

The Yamaha KP65 Kickpad. This large rubber pad is big enough to accommodate a double foot pedal setup.The pad plays quietly with a surprisingly realistic feel. In addition to spurs the base is fitted with a Velcro strip to prevent slippage on carpeted surfaces. Accomodates two beaters (not included); includes stress cable.

Pintech HH-10CV Full Range Hi-Hat pedal The professional HH10-CV HyperHat full velocity hi hat control pedal features an ultra smooth full range control operation for realistic hi hat sounds and other melodic sounds. Other features include spring loaded carpet spikes, no slip rubber pads and Velcro strips on bottom plate.

Pintech Gig Kick Drum

The Hart Hammer Kick Pad