0 Your Cart

MalletKAT / VibeKAT Upgrades and Repairs

$160.00
This FSR Sensor is for the malletKAT Octave Expander, or any octave on the malletKAT except for the master octave (the octave with the function pads and LCD display). Replacement sensor comes with new pads pre-attached.
$160.00
This FSR Sensor is for the malletKAT master octave (the octave with the function pads and LCD display). Replacement sensor comes with new pads and pad shortcut labels pre-attached.
$3.00

If individual pads on your malletKAT have become less responsive or have begun to separate from the sensor, Alternate Mode recommends replacing them.

$129.00
This upgrades your MalletKAT Pro any version 3.0 to a 8.0
$179.00
This upgrades your MalletKAT Pro any version pre 3.0 to a 8.0.  There is a hardware upgrade for versions older than 3.0.  Please contact our office at 877-933-6237 
$99.00
Convert the simplified interface of the vibeKAT to a full featured malletKAT with this chip upgrade.
$99.00

This firmware upgrade chip will provide access to all new performance features introduced in the malletKAT 8. Tested for compatibility with malletKAT version 4 and higher.

PLEASE NOTE: Due to changes in circuit boards over the years, we will need your instrument serial number to send the correct chip. Please include the malletKAT serial number in the COMMENTS section when completing your order.

$48.00
Use these strapping bars to easily attach an Octave Expander to the bottom of the malletKAT.
$35.00
Replacement cable for the malletKAT Octave Expander
$25.00
15V power supply for any KS units including GigKAT